How do I install JA Solar panels?

JA solar recommends installing the modules with a tilt angle of at least 10 degrees, making it easier for dust to be washed off by rain. Ensure the installation method and supporting system of modules is strong enough to make the modules can withstand all the load conditions. The Installer must provide this guarantee.

How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

Where should Trina Solar PV modules be installed?

In most applications, Trina Solar PV modules should be installed in a location where they will receive maximum sunlight throughout the year. Modules should not be shaded by buildings, trees, chimney, etc. at any time of the day. Do not install in corrosive environments, such as beaches or landfill that can be easily flooded.

Can JA Solar modules be installed on a roof?

JA solar modules have been listed as Class A according to IEC 61730-2 standard. For roof installations, modules should be mounted over a fire resistant covering suitable for this application, with adequate ventilation between the modules backsheet and the mounting surface. Roof constructions and installations may affect the fire safety of building.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.